25 (face to trans mount of R154) - 23 (firewall to chassis trans mount) - 2 (trans mount offset).Įxposed's trans mount is not offset and his transmission face sits 4 inches proud of the firewall + 0.625 inch for the adapter plate I imagine. My transmission sits almost flush if not a bit recessed in the trans tunnel, easily verified with the firewall to chassis trans mount measurement the offset nature of my mount and the measurement of the face to the trans mount. The following are just my thoughts for swapping from my R154 to a CD009 using collins adapters adapter. Make sure to factor in the adapter plate width which is an additional 0.625 This was eyeballed measurements on an uncut CD009. Late chassis trans mount span, ~200mm 8 inches Late chassis trans mount bolt spacing ~250mm 10 inches Trans mount bolt pattern 2 bolts 4.25 apart 4 bolts at a V like ~3 inch apart?Įarly chassis trans mount bolt spacing 310mmĮarly chassis trans mount span, 270mm (310mm bolt spacing, 40mm pads, 310-20x2=270) Technically almost 11 inches, but the mounts are kind of rounded so probably closer to 10.5 or 10 inches. Rear box dimension 10w X 12h 9.51w x ?h widest portion of the rear of tranny. Total length 40 28 keep in mind the CD009 has a tripod shifter while the R154 ends at a dust shield for the output They can have sufficient room similar to the 240z with the trans brace removed, maybe more with in some regards with the catalytic converter hump.
They have about 8 inches of space near where the trans cross member bolts through.
Later 240z, 260z, and 280z will need the trans brace removed to fit.
Trans mount holes are 310mm apart center to centerįlange for the mount is roughly 40x40mm, although the outside edge is tapered by trans tunnel as can be seen on exposed's mountsĢ3 inches of room from fire wall to trans mount or 584mm, the closest recorded measurement I have on the diagram is 622.5mm to the TC bucket from the trans mounts. The top of the trans tunnel sits about 285mm off the floor Thanks to body measurements we know the mounts on the body sit about 86mm off the floor pans. Also compiled some measurements based off of my R154 in my 240z.Įarly 240z 70, 71, 72 will physically fit an R154 unaltered, CD009 will fit unaltered per Exposed's picture. Got a chance to do a few measurements on the CD009 and a 280z.
#CD009 TRANSMISSION FREE#
While relatively fresh on my mind. Please feel free to correct!
0 kommentar(er)
